Clie

To program a Q330 with a Clié you need to use either the "Q330 B147" or "Q330 1.491t" program. These programs can be found on the main menu of any Clié received from PASSCAL. These programs are used to send or retrieve parameters/configurations, change station names, change IP addresses, and to send commands to a Q330.

Important note: To program a Q330S (which is different from a normal Q330) you MUST use the program "Q330 1.491t"

This page is meant as a quick reference guide for using the Clié program "PFC-130" to load configuration parameters to a RT130. When deploying RT130's in the field, you will be provided an installation worksheet which covers the same steps but with more detail specific to your experiment.

1. Open PFC-130, on the Clié

2. Select Work with Configuration

3. Load (Load Configuration Pre-Written or Loaded Config File)

4. Select OK

5. Verify Configuration Name top of screen

6. Send to DAS

7. Select OK

8. Select Done

9. Re-Enter Work with Configuration

10. Select from DAS (Load from DAS)

11. Edit

12. Confirm Experiment Name